3d Modeling

Object 1: For this object it wasn't too diffuclt my only problem was the time, because I was using the step by step version on wikipedia, but ulteiamtely switched over to the youtube tutorials as it was easier for me to figure out the build. Although it took some time it helped me understand most of the tools in free cad. I feel like this helped me for the next two objects that I was going to do. Object 2: For object I struggled to find inspiration becauase I didnt want to go the same route of a typical cable holder, so I took up alot of time with a design. While I thought of my design I measure my desk thickness and it was 40mm so I knew I had to make a thicker build because my desk my bigger than usual. Then I came up with a sketch, which looked like a thick clip that was a rectangle cut on the inside alot so it can fit my desk. After I used a cylinder cut up in half so the cale go throuh it and it was part of another rectanglurlar block that was on top of the clip that I sket...